Chapter 5: Management and Diagnostics 25
access from a remote PC. Click Save/Apply and wait several
seconds for the settings to be saved.
2 Click on Status from the left pane of the Zoom
Configuration Manager. Click on WAN. Write down the
public IP address displayed under WAN Info.
3 Type this public IP address into the browser of your remote
PC.
4 At the log in prompt, enter the user name and password shown
below:
User name: support
Password: support
5 You can now view or make changes to your modem’s
configuration from your remote PC.
Changing User Names and
Passwords
Use the Passwords page to manage the user names and passwords
that can access the Zoom Configuration Manager. To open this
page, click on Advanced Setup Æ Management Æ Access
Control Æ Passwords.
When you installed the X3 or X4 and tried to open the Zoom
Configuration Manager, you were prompted for a User Name
and Password in order to gain access. (The default name and
password were supplied to you in the section Establishing
Communication.)
If you want, you can change the default password.
Changing the
password is not required, but as a good security measure, we
recommend it.
To Next Page
Loading...
