Zoom X3 - Appendix C: Tcp;Ip Network; Settings

Appendix C: TCP/IP Network Settings 36
Appendix C: TCP/IP
Network Settings
If you are using a Mac computer, you must ensure that your
computer’s TCP/IP network settings are configured properly.
Otherwise, you will not be able to connect to the Internet.
Note:
If you are using a Windows computer, you do not have to
configure the TCP/IP settings if you are using DHCP because
your Windows computer will automatically configure them for you.
If you are not using DHCP, you will need to set up the TCP/IP
settings for your Windows computer. Windows users who are
troubleshooting the X3 or X4 will need to verify the TCP/IP
settings.
Depending on your operating system, follow the steps in the
appropriate section to ensure your TCP/IP settings are correct.
• If you are using Macintosh, see
Macintosh TCP/IP Settings
on page
36.
• If you are using Windows, see
Windows TCP/IP Settings on
page
38.
Macintosh TCP/IP Settings
How you configure your Macintosh computer’s network settings
differs, depending on your Mac OS. For OS X, follow the
instructions
below. Otherwise, go to page 37.
Mac OS X 10.5 (Leopard)
1 From the Dock or Apple menu, select System Preferences
and then Network.
2
Select your connection method, normally Ethernet for a
wired connection.