©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
38
Once heating is completed, the printer will lift up the platform and display a message in-
dicating that the three calibration screws placed under the platform need to be tightened.
Once you’ve tightened the screws, select Done to continue.
The printer will start to check the distance between the nozzle and five silver points on the
platform: two points at the front of the platform, two points at the back and the center
point.
If the printer detects an incorrect distance in any of these points, the display will show
instructions on what adjustments should be made. Follow the instructions and tighten or
loosen the screw indicated in the message. Once you finish, select Done and the printer
will recheck a given point on the platform.
If the distance between the nozzle and five points is set within the acceptable limits, the
printer will finish the calibration procedure. Additionally, the display will show the calibra-
tion results. Select Done to finish the calibration.
To Next Page
Loading...
