©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
4
General Safety Information
This User Guide contains important safety directions that should be followed during installation
and operation of Zortrax 3D printers. It also mentions situations which require special attention
and includes warnings against negligence and misuse that could cause damages or injuries.
Always read the safety data sheets available at: https://zortrax.com/materials/zortrax-m-series/
They are a source of basic information and safety procedures for the equipment you bought.
It is essential to update the firmware to avoid any kind of failures. Visit our website: https://
zortrax.com regularly to learn about the latest news and updates.
Zortrax 3D printers operate at high temperatures and have easily accessible movable com-
ponents, therefore, you must be particularly careful when handling or operating the devices.
While operating the printer, it is extremely important to avoid situations that may lead to burns
or interference in the device’s proper functioning.
Do not leave the machine unattended during the print job - check it periodically for proper
functioning in order to avoid potential accidents or breakdowns. Turn off the printer once the
print job is finished. Monitor your device for wear and tear regularly. Contact our Support Cen-
ter at: https://support.zortrax.com/ for assistance while replacing worn or broken parts.
Keep the printer away from heat sources, fire, flammable materials, humidity as well as water
and other liquids. Place the machine away from any equipment emitting radiation. To prevent
any inadvertent use, keep the device out of reach of children and animals. It is forbidden to
shake or drop the printer as it may cause breakdowns. The equipment is not intended for use
in a potentially explosive environment.
Health and Safety at Work
All service and maintenance activities as well as device operation require wearing safety gloves
included in the Starter Kit. Wearing safety gloves is also advised while removing the finished
print from the platform.
The Manufacturer strongly recommends setting up a special room dedicated only to 3D prin-
ting and ensure proper ventilation in it. At the same time, the Manufacturer does not recom-
mend staying in a room where devices have been 3D printing for a long time. The vapors
released during the printing process do not pose a direct hazard, but they can have negative
effects when combined with accumulated dust particles in long-term processes.
To Next Page
Loading...
