©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
6
Hot surface. Allow to cool before touching
Due to design characteristics, the screws that secure the Z-axis screw nut cannot be fully
tightened
Do not attempt to modify or remanufacture the product
Remove the print from the platform with extreme care
Wear safety gloves
This symbol indicates that special care should be taken when repairing the device. Also, it
points out an important step to be carried out
While following post-processing procedures, wear safety gloves and glasses in order to
avoid injuries that may be caused by sharp edges and fragile elements of the models.
To avoid injuries, be particularly careful while removing the prints from the platform. Always
wear safety gloves and glasses.
Risk of Burns
There is a high risk of burns while operating Zortrax printers as the extruder’s temperature may
reach up to 290⁰ C [554⁰ F]. Do not touch the extruder with bare hands. Be extremely careful
during maintenance and repair work of heated units. If it is necessary to touch a heated com-
ponent, use the pliers which are specially adapted for this purpose. Cooling of components
should not take less than 30 minutes.
The platform’s temperature can reach up to 105⁰ C [221⁰ F], therefore, special care should be
taken while operating the printer or while removing the finished print.
Do not ignore the warning labels placed on the devices.
Moreover, constructional modifications of the printer’s operating temperature are not permit-
ted as it may cause serious injuries or bring damage to the device.
Warning and Safety Labels on Zortrax Devices
To Next Page
Loading...
