©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
7
Safe Storage and Transport Guidance
Zortrax devices must be stored between 0 and 35⁰ C [32 - 95⁰ F]. The storage space should be
free of moisture and other extreme conditions.
Transport Instructions
When stacking several devices on a pallet, follow the instructions provided on the packaging. One
device may weigh more than 20 kg [44 lb]. It is therefore advisable to provide safe pallet storage
but not higher than 1.7 m [5’7”]. It should be noted that the packages must not project beyond the
outline of the pallet. Packages stacked on the pallet should be then bound together and wrapped in
foil. The pallet prepared as above can be then forwarded to the shipping company.
Pallet stacking and destacking should be carried out by two people. The package with the
device should be lifted or moved using special handles.
Electromagnetic Compatibility (EMC)
Each Zortrax printer complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with this instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own
expense.
The printer needs to be placed on a flat and stable surface to ensure proper quality of the prints
Hot surface. Do not touch
Do not reach into moving elements
To Next Page
Loading...
