12
G41 series motherboard
Connecting Cables and Setting Switches
This section takes you through all the connectors and switch settings necessary on
the motherboard. This will include:
q Power Connections
v 24-pin ATX power-PW1
v 4-pin ATX 12V power-PW2
q Connecting Internal Headers
v Hard Disk Connector-CN1
v SPK Header-SPK1
v COM Header-CN9 (Optional)
v Front Panel Header-FP1
v USB Headers (FP_U1~FP_U2)
v F_Audio Header-FP_S1
v SPDIF-Out Header-CN6
q Serial ATA II
q Chassis Fans
q Expansion slots
q Jumper settings
See Figure 1 to locate the connectors and jumpers referenced in the following
procedure.
To Next Page
Loading...
