Zotac G41 series

22
G41 series motherboard
IDE Conguration
The items in this menu allow you to set or change the congurations for the IDE
devices installed in the system. Press <enter>to display the conguration options:
q ATA/IDE Conguration
The items allow you to congure ATA/IDE.
q Congure SATA as
This item allows you to set the SATA to IDE/RAID/AHCI mode.
q Congure SATA Channels
This item allows you to set the SATA channels [Before PATA] or [Behind PATA].
q Primary, Secondary, and Third IDE Master/Slave
This displays the status of auto detection of IDE devices.
q Hard Disk Write Protect
This item will be effective only if device is accessed through BIOS.
q IDE Detect Time Out (Sec)
The item allows you to select the time out value for detecting ATA/ATAPI devices.
q ATA(PI) 80pin cable detection
The item allows you to select the mechanism for detecting 80pin ATA(PI) cable.
SuperIO Conguration
The items in this menu allow you to congure F71862 Super IO Chipset.
Hardware Health Conguration
This menu gives you an overview of the Hardware Health Conguration.
ACPI Conguration
The items in this menu allow you to set General ACPI Conguration, Advanced ACPI
Conguration and Chipset ACPI Conguration.
MPS Conguration
The item in this menu allows you to select MPS revision. The default setting is 1.1.
PCI Express Conguration
The item in this menu allows you to enable or disable PCI Express L0s and L1 link
power states.
Smbios Conguration
The item in this menu allows you to enable or disable Smbios Smi Support.
Trusted Computing
The item in this menu allows you to enable or disable TCG/TPM support in BIOS.
USB Conguration
The items in this menu allow you to change the USB-related features .Press <enter>
To display the conguration options:
q Legacy USB Support
Allows you to enable or disable support for USB devices on legacy operating
systems.
q USB 2.0 Controller Mode
Allows you to congure the USB 2.0 controller in HiSpeed or Full Speed.