Zotac MAG

Using a dynamic IP (PPPoE connection)
Repeat Step 1-3 in the previous section.1.
Select Obtain an IP address automatically and click OK.2.
Click Create a new connection to start the NEW Connection Wizard.3.
Click Next.4.
Select Connect to the Internet and click Next.5.
Select Set up my connec-6.
tion manually.
Select your connection 7.
type and click Next.
Enter your ISP Name and 8.
click Next.
Enter your User name 9.
and Password. Click
Next.
Click Finish to finish 10.
the configuration.
Enter your user name 11.
and password. Click Con-
nect to connect to the
Internet.
Notice : Contact your internet Service Provider (ISP) if you have problems connect-
ing to the network.
Configuring audio output via an HDMI device
If you use your TV with an HDMI connector as an audio output device, connect it to
your ZOTAC MAG and follow the steps below to configure audio settings:
Note: The screenshots shown in this section are for the Windows® Vista operating system.
Access the Sound settings via the system Control Panel1.
Under Playback devices, click the NVIDIA 2.
HDMI Audio device
Click the “Set as Default” in the lower 3.
right hand corner.
Click OK to exit the setup.4.
9