【Password】Enter the PPPoE password provided by the network operator.
【Authentication Type】Select "Auto".
【IP Version】The default is "Ipv4". ONU itself does not support IPV6.
【Enable NAT】Check the "Enable NAT" function; NAT function is mainly used for
internal network and external network communication address
translation function, the default is checked enabled state, if not
check the network ONU not get the network.
Note: ZTE solution ONU series of products is no port binding function, because
the ONU is SFU (pure data)+ Routing, the ONU either works in SFU mode, or is
working in routing mode.
2. After the above configuration, click "create" button to complete the PPPoE
broadband Internet access settings.
5.1.2 DHCP broadband Internet access in routing mode
1. web login ONU and select Network -> WAN -> WAN Connection, and then set
To Next Page
Loading...
