Zte EPON SFU Series - Routing mode broadband Internet settings

ONU LAN port obtained by the OLT upper layer server. The PC is connected to the
Internet through DHCP, PPPoE, and static ip address.
5.1 Routing mode broadband Internet settings
5.1.1 PPPoE broadband Internet access in routing mode
1. web login ONU and select Network -> WAN -> WAN Connection, and then
set the following parameters:
【Connection name】Select "Create WAN Connection".
【New Connection name】According to own convenience to specify.
【Enable Vlan】This one can be set according to the network planning situation, if
the network planning Internet vlan, this one need to check the
"Enable vlan"; If the network is not planning Internet vlan, this one
does not need to check, then ONU is vlan transparent mode.
【Vlan ID】The same as "Enable Vlan", Setting depending on the network vlan
planning.
【802.1p】Set the priority of vlan, The same as "enable Vlan", depending on the
network vlan planning to configure. The default priority is 0.
【Type】select "Route".
【Service List】Select internet. route mode access internet are generally select
internet.
【MTU】The default is 1492 does not need to modify; if you meet can ping DNS but
the web browser can not access the site. Modify MTU smaller, such
as: 1400.
【Link Type】Select "PPPoE".
【Username】Enter the PPPoE Internet PPPoE account provided by the network
operator.