To Next Page

To Previous Page

2.After the above configuration, click "create" button to complete the Static IP

broadband Internet access settings.

5.2 Broadband Internet Access In Bridge Mode

ZTE solution ONU series products factory default mode in the bridge (pure data

SFU), ONU bridge mode Internet does not need to do any configuration in the web

interface. Just configure the correct ONU port vlan (eg access, trunk, transparent)

in the OLT

Note: If ONU was in route mode for Internet. Please disable ONU’s DHCP function

if need change to bridge mode. It is best to delete route WAN configuration.

5.3 View Broadband WAN Status

web login ONU and select the status -> Network interface -> WAN

Connection, you can see the status of the WAN connection in the routing mode,

check whether the routing WAN has the correct IP address, and whether the bridge

WAN status is "UP"

Questions and Answers:

Need help?

Do you have a question about the Zte EPON SFU Series and is the answer not in the manual?

Zte EPON SFU Series Specifications

General