EasyManuals Logo

Zte EPON SFU Series User Manual

Zte EPON SFU Series
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
network vlan planning to configure. The default priority is 0.
TypeSelect "Route".
Service ListSelect internet. route mode access internet are generally select
internet.
MTUThe default is 1492 does not need to modify; if you meet can ping DNS but
the web browser can not access the site. Modify MTU smaller, such
as: 1400.
Link TypeSelect "IP".
IP VersionThe default is "Ipv4". ONU itself does not support IPV6.
IP TypeSelect "static".
Enable NATCheck the "Enable NAT" function; NAT function is mainly used for
internal network and external network communication address
translation function, the default is checked enabled state, if not
check the network ONU not get the network.
Ip Address Static ip address access Internet.
Subnet MaskSubnet Mask of Static ip address.
GatewayThe default gateway for static ip address Internet access.
DNS Server1 IP Address/DNS Server2 IP Address/DNS Server3 IP AddressThe
first DNS, the second DNS and the third DNS for for static ip
address Internet access.
Note: ZTE solution ONU series of products is no port binding function, because
the ONU is SFU (pure data)+ Routing, the ONU either works in SFU mode, or is
working in routing mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zte EPON SFU Series and is the answer not in the manual?

Zte EPON SFU Series Specifications

General IconGeneral
BrandZte
ModelEPON SFU Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals