9GETTING STARTED
8 GETTING STARTED
Installing the microSDHC
™
Card (not included)
The microSDHC card can be installed and removed while the phone is turned
on. Unmount the microSDHC card before removing or replacing it.
1. Remove the back cover.
2. Hold your microSDHC card with the metal
contacts facing down and slide it into the card slot.
3. Press the back cover gently back into place until you
hear a click.
Note: Some applications may require a microSDHC card
to work normally or may store certain data on it. Therefore,
it is recommended that you keep a microSDHC card installed
and not remove or replace it randomly.
Charging the battery
Although the battery comes partially charged, it is recommended you fully
charge the battery before using your phone for the rst time.
If the battery is low, there will be a pop-up message
on the screen. As you charge your phone, the screen
will tell you the exact battery level each time you wake
up your phone.
Warning! Use only ZTE-approved chargers and cables.
The use of unapproved accessories could damage
your phone or cause the battery to explode.
1. Insert the charger’s connector into the charging port. Be sure to insert
the connector in the correct orientation. Do not force the connector into
the port.
2. Plug the charger into a standard AC wall outlet.
3. When the battery is fully charged, unplug the charger and disconnect it
from the phone.
Extending the battery life
Active applications, screen brightness levels, Bluetooth and Wi-Fi usage and
GPS functionality can drain your battery. You can follow the helpful tips below
to conserve your battery power:
• Reduce the screen backlight time.
• Lower the screen brightness.
• Turn auto-sync, Wi-Fi, and Bluetooth off when not in use.
• Disable the GPS function when not in use. Most applications using this
function will periodically query the GPS satellites for your current location;
each query drains your battery.
Switching your phone on/off
Make sure the SIM card is in your phone and the battery is charged.
• Press and hold the Power key to turn on your phone.
• To turn it off, press and hold the Power key to open the options menu.
Tap Power off > OK.
Setting up your phone for the rst time
When you rst power on your phone after you purchase it or reset it to factory
settings (see Phone settings – Backup & reset), you need to set up your
phone settings before using it.
1. Scroll the language list to highlight the language you need and then
tap Start.
2. Select a Wi-Fi
®
account to connect your phone to or tap Skip.
To Next Page
Loading...
