Zte MAX XL - Wi-Fi Calling Settings; Bluetooth Settings

Connections Settings 189
● Use WPS to Connect to a Wi-Fi Network: From Wi-Fi settings, tap Menu > Advanced >
WPS Push Button or WPS Pin Entry.
 The settings are available when Wi-Fi is turned on.
 If you tap WPS Push Button, press the WPS button on the access point and the access
point will recognize your phone and add it to the network.
 If you tap WPS Pin Entry, enter the PIN number displayed on the phone into the access
point's setup page. Your phone automatically finds the access point and configures the
connection.
Note: For detailed information about the WPS feature of the access point, please refer to its user
documents.
● Allow Automatic Connection to Passpoint-certified Wi-Fi Access Points: From Wi-Fi
settings, tap Menu > Advanced and tap the Passpoint slider.
● Enable Notification when Open Networks Are Available: From Wi-Fi settings, tap and tap
the Network notification slider.
 The setting is available when Wi-Fi is turned on.
 Tap Network notification to turn the option on or off.
● Set Timing for Pausing a Connection: From Wi-Fi settings, tap > Keep Wi-Fi on during
sleep and then select a setting.
● Check MAC Address: From Wi-Fi settings, tap .
 MAC Address appears below “MAC address.”
● Check IP Address: From Wi-Fi settings, tap .
 IP Address appears below “IP address.”
Wi-Fi Calling Settings
The Wi-Fi Calling settings menu lets you set your Wi-Fi Calling options, including updating your 9-1-1
information. For information about setting up Wi-Fi Calling, see Wi-Fi Calling.