22 Confidential and Proprietary Information of ZTE CORPORATION
Advanced
Select Wi-Fi Setting > Advanced, the advanced wireless network parameters are shown in the following
figure:
• Beacon Interval: The router broadcasts beacon message to announce that it has buffered frames to
deliver. The default value is 100 (ms).Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. is recommended.
• Data Beacon Rate(DTIM): A Delivery Traffic Indication Message(DTIM) informs next clients to listen
to broadcast and multicast messages.
• Fragment Threshold: This value should remain at its default value of 2346. If you experience a high
packet error rate, you may slightly increase your fragment threshold. Setting the fragment threshold too
low may result in poor performance.
• RTS Threshold: Request To Send (RTS) threshold should be remained as the value of 2347. If you
encounter inconsistent data flow, only minor modifications are recommended.
• TX Power: Transmit power should be remained as the value of 100.
• Short Preamble: The length of CRC block in the frames during the wireless communication.
• Shot Slot: To indicate that 802.11g is using a shot time slot because there is no legacy station(802.11b)
present.
• Tx Burst: Tx burst allows router to deliver better throughput in the same period and environment in
order to increase speed.
• Pkt_Aggregate: Increase efficiency by aggregating multiple application packets data into a single
transmission frame. In this way, 802.11n networks can send multiple data packets with the fixed
overhead cost in just a single frame.
Country Code: Select the region you live.
The Wi-Fi multimedia parameters are shown below:
• WMM Capable: When multimedia contents are transferred over wireless network, this function
enhances data transfer performance.
To Next Page
Loading...
