Zte MF25 - WDS Mode

Confidential and Proprietary Information of ZTE CORPORATION 21
• BSSID: MAC address of the Wi-Fi.
• Frequency(Channel): Choose the appropriate channel to optimize the performance and coverage of
your wireless network.
• WDS Mode: WDS enable router to communicate with other APs, WDS connection is two-way
communication, APs should know each other’s wireless MAC address. And make sure that all APs
share the same SSID and channel.
WDS configuration is shown below:
Step
Description
1.Set the same SSID and channel for APs
Manually set the SSID and channel is strongly
recommended.
2.Select WDS mode: Disable, Lazy Mode, Bridge Mode or
Repeater Mode
·If you select Disable, WDS is disabled.
·If you select Lazy Mode, WDS is enabled, and set
wireless MAC address only on the peer APs.
·If you select Bridge Mode, WDS is enabled, and set the
peer APs wireless MAC address on router. When you set
Bridge Mode, your PC can not search SSID of AP after
connected.
·If you select Repeater Mode, WDS is enabled, and set
the peer APs wireless MAC address on router. When you
set Repeater Mode, your PC can search SSID of AP after
connected.
3.Select Phy mode:
CCK,OFDM, HTMIX or GREENFIELD
CCK: 802.11b
OFDM: 802.11g
HTMIX: 802.11b/g/n Mixed Mode
GREENFIELD: 802.11b/g Mixed Mode
4.Select Encrypt Type:
WEP, TKIP, AES
If you select NONE, all the data transmitted without
encryption, and other station can access router.
5.Set peer AP's wireless MAC address on router
Only Repeater Mode and Bridge Mode need this.
The HT physical Mode parameters are shown below:
• Operating Mode: In Mixed Mode, packets are transmitted with a preamble compatible with the legacy
802.11a/g, the rest of the packet has a new format. In Green Field, high throughput packets are
transmitted without a legacy compatible part.
• Channel Bandwidth: Set the HT physical channel bandwidth.
• Guard Interval: Guard interval is to introduce immunity to propagation delays, echoes and reflections,
to which digital data is normally very sensitive.
• MCS: The Modulation and Coding Scheme (MCS) is a value that determines the modulation, coding and
number of spatial channels.
• Reverse Direction Grant(RDG): Enable RDG or not.
• Extension Channel: Set extension channel. Extension channel is also able to send and receive data.
• Aggregation MSDU(A-MSDU) :To enable Hyper Throughput TX Aggregate MAC Service Data Unit,
select Enable.
• Auto Block ACK: Select to block ACK (Acknowledge Number) or not during data transferring.
• Decline BA Request: Select to reject peer BA-Request or not.
Click Apply to confirm your configuration.