To Next Page

To Previous Page

Notes:

Then there will be a pop-up window to require the password. You can connect the device with the

computer by RJ45 Ethernet cable, and then login the WebGUI to gain the SSID and password by selecting

Settings > Wi-Fi Settings > Security.

4. Wait a moment, the connection between your device and the client will be established

successfully.

Accessing the Internet

Before accessing the internet, make sure;

1. Switch on the device.

2. Establish a connection between your device and the client.

Accessing the Internet by Bridge Mode

1.Connect the device with LAN port.

2.Login the WebGUI and set the Operation Mode as Bridge mode.

Accessing the Internet by Cable Broadband

1.Connect the device with LAN1/WAN port.

2.Login the WebGUI and set the Operation Mode as Cable Broadband mode.

3.Set WAN Connection in WebGUI.

Accessing the Internet by LTE Gateway

Note: Please make sure that you have install (U)SIM card before you switch on the device.

1.Login the WebGUI and set the Operation Mode as 4G Gateway.

2. Set WAN Connection in WebGUI.

Accessing the WebGUI Configuration Page

1. Make sure the connection between your device and the client is correct.

2. Launch the internet browser and enter http://192.168.1.1 in the address bar.

Notes:

It is recommended that you use IE (7.0 or later), Firefox (3.0 or later), Opera (10.0 or later), Safari

(4.0 or later) or Chrome (10.0 or later).

3.The login page appears as follows.

Zte MF28B User Manual

Other manuals for Zte MF28B