To Next PageTo Next Page
Need help?Do you have a question about the Zte ZXR10 5900 Series and is the answer not in the manual?
General| Type | Fixed configuration |
|---|---|
| Layer Support | Layer 2/Layer 3 |
| VLAN Support | 4K VLAN |
| QoS | 8 priority queues |
| Security | ACL, 802.1X |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -40°C to 70°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Humidity | 5% to 95% (non-condensing) |
Provides guidance for installation, operation, and maintenance.
Describes different modes for configuring the switch based on network connection.
Covers procedures for upgrading software versions, including abnormal cases.
Details GE and XGE port capabilities and naming conventions.
Overview of IP addressing, classes, and subnetting.
Introduces switch stacking, main device, and management modes.
Details member roles, election rules, and ID management.
Explains the rules for electing the main device in a stack.
Provides commands for configuring switch stack system features.
Explains packet filtering, ACL types, and matching rules.
A comprehensive example demonstrating ACL configuration.
Explains the need for QoS and its functions like traffic classification.
A typical QoS configuration example demonstrating various features.
Explains DHCP basics, its operation, and IP address allocation mechanisms.
Covers configuring IP pools, conflict times, and reserved addresses.
Steps to enable/disable DHCP server and configure working modes on interfaces.
Details DHCP snooping configuration, including binding, VLANs, and trust settings.
Explains VRRP, virtual routers, and master/backup roles.
Commands for configuring VRRP group, priority, preemption, and advertisements.
Provides examples for basic and symmetric VRRP configurations.
Overview and configuration of Network Time Protocol (NTP) for time synchronization.
Explains RADIUS overview and how to configure accounting and authentication groups.
Overview of SNMP and configuration of communities, views, traps, and hosts.
Overview and configuration of TACACS+ for centralized authentication and authorization.
Explains DOT1X, its architecture, and roles (supplicant, authenticator).
Covers AAA control entry creation, DOT1X control, and authentication modes.
Example of configuring DOT1X with RADIUS authentication.
Defines cluster management, types of switches, and roles.
Steps to set switch types and establish clusters.
Introduces ZESR/ZESR+ for solving layer 2 loop problems and their advantages.
An example demonstrating ZESR configuration in a ring network.
Overview and configuration of IP Source Guard based on DHCP snooping.
Examples for IP Source Guard configuration based on IP, MAC, or both.
Overview and configuration of control plane security for switch protection.
Overview and configuration of Dynamic ARP Inspection (DAI).
Explains Power over Ethernet (PoE) and its benefits for network devices.
