Need help?Do you have a question about the Zte ZXR10 5250-52TC and is the answer not in the manual?
General| Model | ZXR10 5250-52TC |
|---|---|
| Category | Switch |
| Forwarding Rate | 132 Mpps |
| VLANs | 4K |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -40°C to 70°C |
| Ports | 48 x 10/100/1000BASE-T ports, 4 x 10G SFP+ ports |
| Power Supply | AC: 100~240V, 50/60Hz |
| Dimensions | 440mm x 44mm x 220mm |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Humidity | 5% to 95% RH |
General safety guidelines for equipment installation, operation, and maintenance.
Configuration of general management settings, including hostnames and system information.
Configuration of port parameters, including enabling/disabling, speed, duplex, and flow control.
Configuration related to Power over Ethernet (PoE) for ports.
Configuration and management of VLANs, including enabling/disabling, port assignment, and trunk configuration.
Configuration and management of MAC addresses, including security, filtering, learning, and limits.
Configuration for IGMP snooping, including enabling/disabling, VLAN management, and filtering.
Configuration for IPTV services, including channel groups, CDR, and preview settings.
Configuration for Spanning Tree Protocol (STP), including enable/disable, port settings, and instances.
Configuration of Access Control Lists (ACLs) for packet filtering.
Configuration of Quality of Service (QoS) parameters, including priority mapping, traffic shaping, and policing.
Configuration of IPv4 Layer 3 features, including ping, trace, and port settings.
Configuration for access services like 802.1x authentication and RADIUS.
Configuration for DHCP snooping, option82, and IP source guard.
Configuration for DHCPv6 snooping, option18, option37, option82, and IP source guard.
Configuration for Multicast Listener Discovery (MLD) snooping.
Configuration for detecting loops on single ports and trunks.
Configuration for UniDirectional Link Detection (UDLD) protocol.
Configuration for TACACS+ authentication, authorization, and accounting.
Configuration for DHCP relay functionality, including server settings and option82.
Configuration of remote access control to the switch.
Configuration for Secure Shell (SSH) service.
Configuration for Simple Network Management Protocol (SNMP), including engine ID, communities, views, and traps.
To Next Page
