17
• AP Isolation: When Enabled is selected, each of your wireless clients will not be able to communicate
with each other. Otherwise, the wireless communication via WLAN is available.
• Frequency(Channel): Choose the appropriate channel to optimize the performance and coverage of
your wireless network.
•The HT physical Mode parameters are shown below:
• Channel Bandwidth: Set the HT physical channel bandwidth.
• Guard Interval: Guard interval is to introduce immunity to propagation delays, echoes and reflections,
to which digital data is normally very sensitive.
• Extension Channel: Set extension channel. Extension channel is also able to send and receive data.
Click Apply to confirm your configuration.
Advanced
Select Wi-Fi Setting > Advanced, the advanced wireless network parameters are shown in the following
figure:
• Beacon Interval: The router broadcasts beacon message to announce that it has buffered frames to
deliver. The default value is 100 (ms).Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. is recommended.
• Data Beacon Rate(DTIM): A Delivery Traffic Indication Message(DTIM) informs next clients to listen
to broadcast and multicast messages.
• Fragment Threshold: This value should remain at its default value of 2346. If you experience a high
packet error rate, you may slightly increase your fragment threshold. Setting the fragment threshold too
low may result in poor performance.
• Short Preamble: The length of CRC block in the frames during the wireless communication.
Click Apply to confirm your configuration.
Security
Select Wi-Fi Setting > Security, the Security parameters are shown in the following figure:
To Next Page
Loading...
