Zte MF29A - Page 24

24
• Wi-Fi On/Off: Enable or disable Wi-Fi.
• Network Mode: If all of the wireless devices connect with this router in the
same transmission mode, performance will be improved by choosing the ap-
propriate wireless mode.
• Network Name(SSID): Service Set Identier (SSID). Enter a string less than
32 characters as the name for your wireless local area network (WLAN).
• Broadcast Network Name(SSID): Disable or Enable (Default) this function.
If Enable is selected, the router broadcasts the SSID, and other devices can
detect and connect to it. If Disable is selected, the other devices cannot detect
the router. You can only connect to the router by manual setting.
• AP Isolation: When Enabled is selected, each of your wireless clients will not
be able to communicate with each other. When Disable is selected, each of
your wireless clients will be able to communicate with each other.
• BSSID: MAC address of the Wi-Fi.
• Frequency(Channel): Choose the appropriate channel to optimize the perfor-
mance and coverage of your wireless network.
• WDS Mode: WDS mode make the router to communicate with other APs, WDS
connection is two-way communication, APs should know each other’s wireless
MAC address. And make sure that all APs share the same SSID and channel.
WDS conguration is shown below:
Step Description
1.Set the SSID and the
same channel for APs
It is strongly recommended to manually set the SSID
and the same channel.