Zte MF29A - Page 25

25
Step Description
2.Select WDS mode:
Disable, Lazy Mode,
Bridge Mode or Re-
peater Mode
If you select Disable, WDS is disabled.
If you select Lazy Mode, WDS is enabled, and set
wireless MAC address only on the peer APs.
If you select Bridge Mode, WDS is enabled, and set
the peer APs wireless MAC address on router. When
you set Bridge Mode, your PC can not search for
SSID of AP after connected.
If you select Repeater Mode, WDS is enabled, and set
the peer APs wireless MAC address on router. When
you set Repeater Mode, your PC can search for SSID
of AP after connected.
3.Select Phy mode:
CCK,OFDM, HTMIX or
GREENFIELD
CCK: 802.11b
OFDM: 802.11g
HTMIX: 802.11b/g/n Mixed Mode
GREENFIELD: 802.11b/g Mixed Mode
4.Select Encrypt Type:
WEP, TKIP, AES
If you select NONE, all the data transmitted without
encryption, and other station can access router.
If you select the Encrypt Type, you should set all APs
the same Encrypt type and password to make the data
transfer.
5.Set peer AP's wireless
MAC address on router
Only Repeater Mode and Bridge Mode need this.