Comment: type comment for the filter settings.
Note：Filtering rules are matched one by one, if met this provision, it
will not continue to match the rules listed below.
Click Apply to confirm your configuration. Click Delete to delete the
rule which you selected. Click Reset to clear what you select or input.
To add a new rule:
a) Select Enable and click Apply in the Basic Settings area.
b) Input the detail information in the Mac/Ip/Port Filtering area.
c) Click Apply in the Mac/Ip/Port Filtering area.
2. URL Filtering
You can setup content filter to restrict the improper content access.
Select Firewall→URL Filtering, the URL Filtering is shown in the
following figure:
Type URL address, and then click Add to add the URL address into the
filtering list. The new URL filtering item will be shown in the Current
Webs URL Filters: field.
3. Port Forwarding
You can setup virtual servers to provide services on the Internet.
Select Firewall→Port Forwarding, the virtual server settings is shown
in the following figure:
To Next Page
Loading...
