Zte WP560 - Service Status Check

ZTE WP560/960 User Manual
5.3 Service Status Check
Display in service area: Turn on the FWP power, when the power cable is
connected properly, the FWP’s LCD window will light up and LOGO will be
displayed. The FWP will start to search for local CDMA digital network signals.
Once the network is found and the service is available, as shown in Fig. 1, you can
make a call.
Display in area with no service: When there is no service in your area, “No
Service!” will be displayed on the FWP. If the FWP still tries to search for local
CDMA digital network signal when there is no network, as shown in Fig. 2, in this
case please contact the local customer service.
Fig. 1 Fig. 2
17