ZTE WP560/960 User Manual
activate the function of Call Forwarding.
3） The number of Voice Message is provided by the operator. Users can edit in
the editing interface of VM center code (refer to 9.2.4).
The function of Voice Message must be activated by the operator. If it is not
activated, voice messages cannot be received even if the number is set. Before using
this service, please confirm Call Forwarding and Message Receiving have been
enabled for your FWP
Please consult the local operator on how to leave/read a voice message and
consult them for the parameters of Voice Message (such as capacity, time for
recording, etc.)
9.2.4 SMS Setting
Function overview
Submenus for SMS Setting include ①Alert Type②Priority③Lifetime④
Delivery ACK⑤Center code ⑥Call Back#.
Press digital key<5>under SMS interface, you can enter 【SMS Setting
】.
Operation guide
1） Alert Type
Two types of alert are available:
Bell: when a new message is received, the FWP will give an alert in 4
continuous “di” sounds. At the same time, the LCD window will lighten up to
display the information of the message sender.
40
To Next Page
Loading...
