Zte ZXHN H108L - Connection Cable Checks

Chapter 1 - Introduction
Confidential and Proprietary Information of ZTE CORPORATION 3
There are 9 indicators on the front panel of a ZXHN H108L indicating
the running status of the device, as shown in Figure 1. These
indicators are described in Table 5.
TABLE 5 DES CRI P TI ONS FOR TH E IN DIC A TO RS
Indicator
Color
Description
Power
Red/Gr
een
 Red:Indicates the power is just connected or it fails to
function.
 Green Steady on: Indicates switched on.
 Off: Indicates the power has not been connected
DSL
Green
 Steady on: Indicates a DSL link is established.
 Slow flashing: Indicates no signal is detected.
 Fast flashing: Indicates the MODEM is activating.
Internet
Green
 Steady on: Indicates operating in Route mode and
the ADSL link is established. The IP data packet of
the MODEM can be transmitted and received normally
(For example, the embedded PPPOE link is
established and a dynamic IP address is allocated.).
 Flashing: Indicates operating in Route mode and
there is data packet passing the MODEM.
 Off: Indicates operating in Bridge mode or ADSL link
is not established.
Red
 Red on: Device attempted to become IP
connected and failed (no DHCP response, no
PPPoE response, PPPoE authentication failed,
no IP address from IPCP, etc.)
LAN1
LAN2
LAN3
LAN4
Green
 Steady on: Indicates a LAN connection is established.
 Flashing: Indicates data is transmitting.
 Off: Indicates the LAN connection has not been
established
WLAN
Green
 Steady on: Indicates the wireless module is on.
 Flashing: Indicates wireless data is transmitting.
 Off: Indicates the wireless module is off.