ZXHN H108L Wireless ADSL Router Maintenance Manual
22 Confidential and Proprietary Information of ZTE CORPORATION
Select whether your connection is always on or if it connects on
demand. If on demand specify how many minutes the connection
may be idle before it disconnects
Enter the TCP MSS to be used
Choose whether the ZXHN H108L obtains the IP address statically
or dynamically
Enter the static IP address. Only if static IP is selected.
Enter the IP subnet mask. Only if static IP is selected.
Enter the gateway address. Only if static IP is selected.
Select whether NAT is enabled or disabled
Select whether this PVC will be the default route for the Internet
data
Select the RIP type and direction form the dropdown lists
Select the multicast protocol to be used from the dropdown list
Disabled in default, Select Enabled to set a fake MAC of modem
Select the way of Modem to get IPv6 address
Usually select Enable, or modem can’t access internet
Select whether MLD Proxy is enabled or disabled
Select whether enable DS Lite
Note: The parameters listed in Table 10 should be
provided by the ISP. The user name must be asigned by
the ISP.
Bridge Mode
Figure 11 shows the bridge mode parameters on the web
configuration page and Table 11 gives the parameter descriptions.
To Next Page
Loading...
