Zte ZXHN H298N - SSID Settings

Table10IEEE802.11nOnlyParameters
ParameterDescription
WirelessRFModeSelectEnabledtoenablethewirelessRFfunction.
EnableIsolationWhenyouselectthischeckbox,thesubscriberswithdifferent
SSIDscannotvisiteachother.
ModeSelecttheworkingmodeaccordingtothewirelessnetworkcard
conguration.
Country/RegionSelectthecountryorregion.
BandWidthYoucanselect20Mhzor40Mhz.
ChannelThedefaultisAuto.
SGIEnableSelectthischeckboxtoenabletheshortGIfunction.
BeaconIntervalTimeintervalforthewirelessdevicetobroadcasttheSSID
Keepthedefaultvalue.
TransmittingPowerSelectthetransmittingpowerasrequired.
QoSTypeTypeofQoS
RTSThresholdSpecifytheRequesttoSendthresholdforapacket.Whena
packetexceedsthisvalue,thedevicesendstheRTSvaluetothe
destinationpointfornegotiation.Thedefaultis2347.
DTIMIntervalThevaluerangeisfrom1msto5ms.Thedefaultis1ms.
3.ClickSubmit.
4.2.2SSIDSettings
PerformthisproceduretoconguremultipleSSIDs.
TheZXHNH298NcanbespeciedwithfourSSIDsandeachSSIDsupportsupto32subscribers.
Steps
1.Choose[Network→WLAN→SSIDSettings].
2.SelectanSSIDfromtheChooseSSIDdrop-downlist,asshowninFigure26.
41