Zte ZXV10 B700 - Checking Wireless Signal Status

6.SelectSearchintheServicesSettingspagetondnearbyAP .Afterthat,selectanAP .
7.Setthefollowingparameters:authenticationmode,encryptionmode,encryptionkey,encryption
keyID.Aftersettings,selectNext.
Note:
DifferentAPneedstosetdifferentparameters.Settheparametersaccordingtotheon-sitede-
mandsofAP .
8.Setnetworkparameters.
Selectanaccessmodeaccordingtothenetworksituation.
AccessModeParameterDescription
PPPoE�User:ADSLusername
�Password:ADSLpassword
DHCPItisnotnecessarytosetanyparameters.TheSTBgetstheparameters(such
asIPaddress,gateway)automatically.
LAN�IPAddress:IPaddressofSTB
�Mask:SubnetmaskofSTB
�Gateway:GatewayofSTB
�DNSServer:DNSaddressofSTB
9.Aftersettings,selectOKtoreturntotheCongurationpageandresettheSTB.
10.Afterresetting,theSTBconnectstoEPGserveriftheparametersarecorrectlyset.
Note:
MakesurethattheAPrunsnormallybeforereset.
CheckingSignals
Afterwirelessconguration,youneedtocheckwirelesssignalsaccordingtothefollowingprocedure:
1.PressSETtoenterCongurationpage.
2.UsedirectionbuttonstoselectNetworkInformation.EntertheNetworkInformationpage.
ObservethewirelesssignalstatusaccordingtoWLANStatus,WLANIntensity.
SignalIntensitySignalStatus
0-34Poor
35-54Medium
21