ZXV10 W300 (V5.2) Wireless ADSL Router Maintenance Manual
Rear Panel
F I G U R E 2 R E A R P A N E L
There are seven ports and buttons on the rear panel of a W300, as shown in
Figure 2. These ports and buttons are described in Table 6.
T A B L E 6 D E S C R I P T I O N S F O R T H E PO R T S A N D BU T T O N S
Identification Description
POWER
Connected to the companion power adapter.
SWITCH
Power switch
LINE
Connected to the ADSL line or splitter via RJ-11 telephone line.
LAN1~ LAN3 &
STB
Connected to PC’s network interface card (NIC) or another
network device via RJ-45 cable. For Ethernet uplink mode,
connect the Ethernet subscriber line to LAN1 port.
System Requirements
System requirements for the W300 router are as follows:
The user has already subscribed the ADSL or Ethernet service. The service
provider shall provide at least one legal IP address (allocated either
statically or dynamically).
One or more PCs with 10/100M Ethernet Network Interface Card (NIC).
4 Proprietary Information of ZTE CORPORATION
To Next Page
Loading...
