Chapter 2 - Product Installation
F I G U R E 7 T H E I N T E R F A C E S E T U P P A G E
Three sub-pages are under the Interface Setup page, which are Internet,
LAN and Wireless.
Internet Configuration
By default the Interface Setup page displays the Internet configuration
page as shown in Figure 7.
ATM VC and ATM Qos
Asynchronous transfer mode (ATM) is a protocol that arranges data into
small, uniform-sized cells with VCI data, as opposed to variable-sized data
packets. ATM settings are used to connect to ISP. ISP provides the VPI and
VCI setting information. The users of W300 can configure up to 8 virtual
circuits (VC), each using different encapsulation. Each VC must be activated
to take effect. For permanent virtual circuit (PVC) management, users can
use ATM Quality of Service (Qos) to set up each PVC traffic line’s priority.
Proprietary Information of ZTE CORPORATION 17
To Next Page
Loading...
