Zte ZXV10 W300 - Table 11 the Descriptions of the Bridge Mode Parameters

Chapter 2 - Product Installation
Parameter Description
Static IP
Address Enter the static IP address. Only if static IP is selected.
IP Subnet Mask
Enter the IP subnet mask. Only if static IP is selected.
Gateway
Enter the gateway address. Only if static IP is selected.
NAT
Select whether NAT is enabled or disabled
Default Route Select whether this PVC will be the default route for the Internet
data
Dynamic Route
Select the RIP type and direction form the dropdown lists
Multicast
Select the multicast protocol to be used from the dropdown list
Note: The parameters listed in Table 10 should be provided by the ISP. The user name
must be asigned by the ISP.
Br idge Mode
Figure 12 shows the bridge mode parameters on the web configuration page
and Table 11 gives the parameter descriptions.
F I G U R E 1 2 B R I D G E M O D E P A R A M E T E R S
T A B L E 1 1 T H E D E S C R I P T I O N S O F T H E BR I D G E M O D E P A R A M E T E R S
Parameter Description
Encapsulation
Select the encapsulation type from the dropdown list
Proprietary Information of ZTE CORPORATION 23