- 20 -
C141500900.fm
User's manualAMBROGIO 3000
GB
Working phase commands
During the working phase the following
functions can be performed by the lawn
mower using the indicated buttons:
– press PAUSE to stop the lawn mow-
er, press it again to restart it;
– press CHARGE to send the lawn
mower to the recharging base to re-
charge batteries.
When the lawn mower is recharging
press the same button to make it leave
the recharging base and restart work-
ing.
– Press the Key (-) to stop the blade;
– press the Key (+) to start the blade;
–press ENTER to start the "spiral"
working program.
CUTTING HEIGHT - SETTING
Cutting height can vary from 2 to
7 cm, according to the desired
height of the grass.
Danger - Attention
Before performing this setting
turn the mower off by pressing
OFF/STOP.
1-Remove the cutting blade.
2-Unscrew the locking screw.
3-Manually lift or lower the cut-
ting unit until desired height is
reached, as indicated on the
graduated plate.
4-When adjustment is conclud-
ed tighten fastening screws
and reassemble the blade.
LAWN MOWER BALANCING-- ADJUSTMENT
The lawn mower is supplied with
balance adjusted for flat grounds.
In case of sloped grounds, the
lawn mower balance can be mod-
ified by moving both batteries for-
wards or backwards.
1-Unscrew both nuts (A) and re-
move the top hood.
IDM - 41500901500.tif
IDM - 41500900400.tif
IDM - 41500904300.tif
nuts (A)
To Next Page
Loading...
Need help?
General