• Duration (sec): This setting is only available if the reply control mode is on Delay Reset,
it represents the time duration when the configure interface status changed.
API Settings
This page is used to configure the API interface of the device. Through the API interface, you
can realize device linkage, call control, relay control, and play sound by using the changing
status of the call and/or relay.
Path: Advanced/API Settings
• Call Event URL Callback
When the call status changes, it will trigger an HTTP GET request to call a URL address.
Within the URL address, you may use variables to identify some current information. For
example,
${ip}: The current IP address of the device
${mac}: The current MAC address of the device
${ua}： The account of the current call
${number}： The number of the current call
• Relay Event URL Callback
When the relay status changes, it will trigger an HTTP GET request to call a URL address.
Within the URL address, you may use variables to identify some current information. For
example,
${ip}: The current IP address of the device
${mac}: The current MAC address of the device
To Next Page
Loading...
