Chapter 4 Quick Setup Wizards
ZyWALL 110/310/1100 Series User’s Guide
45
Figure 25 WAN Interface Setup: Step 2
The screens vary depending on what encapsulation type you use. Refer to information provided by
your ISP to know what to enter in each field. Leave a field blank if you don’t have that information.
Note: Enter the Internet access information exactly as your ISP gave it to you.
4.2.3 Configure WAN Settings
Use this screen to select whether the interface should use a fixed or dynamic IP address.
Figure 26 WAN Interface Setup: Step 2
• WAN Interface: This is the interface you are configuring for Internet access.
• Zone: This is the security zone to which this interface and Internet connection belong.
• IP Address Assignment: Select Auto If your ISP did not assign you a fixed IP address.
Select Static if you have a fixed IP address.
4.2.4 WAN and ISP Connection Settings
Use this screen to configure the ISP and WAN interface settings. This screen is read-only if you set
the IP Address Assignment to Static.
Note: Enter the Internet access information exactly as your ISP gave it to you.
To Next Page
Loading...
