Chapter 7 Wireless LAN
AMG1302/AMG1202-TSeries User’s Guide
104
Note: At the time of writing, WDS is compatible with other ZyXEL APs only. Not all models
support WDS links. Check your other AP’s documentation.
Click Network Setting > Wireless > WDS. The following screen displays.
Figure 35 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
7.7 The WMM Screen
Use this screen to enable WiFi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
Table 24 Network Setting > Wireless > WDS
LABEL DESCRIPTION
WDS Security Select the type of the key used to encrypt data between APs. All the wireless APs
(including the AMG1302/AMG1202-TSeries) must use the same pre-shared key for data
transmission.
The option is available only when you set the security mode to WPA(2) or WPA(2)-
PSK in the Wireless > General screen.
TKIP Select this to use TKIP (Temporal Key Integrity Protocol) encryption.
AES Select this to use AES (Advanced Encryption Standard) encryption.
# This is the index number of the individual WDS link.
Active Select this to activate the link between the AMG1302/AMG1202-TSeries and the peer
device to which this entry refers. When you do not select the check box this link is down.
Remote Bridge
MAC Address
Type the MAC address of the peer device in a valid MAC address format (six hexadecimal
character pairs, for example 12:34:56:78:9a:bc).
PSK Enter a Pre-Shared Key (PSK) from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
