Chapter 25 Remote Management
AMG1302/AMG1202-TSeries User’s Guide
227
Use this screen to specify which interfaces allow FTP access and from which IP address the access
can come. To change your AMG1302/AMG1202-TSeries’s FTP settings, click Maintenance >
RemoteMGMT > FTP. The screen appears as shown.
Figure 119 Maintenance > RemoteMGMT > FTP
The following table describes the labels in this screen.
25.5 The SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your AMG1302/AMG1202-TSeries supports SNMP agent functionality,
which allows a manager station to manage and monitor the AMG1302/AMG1202-TSeries through
the network. The AMG1302/AMG1202-TSeries supports SNMP version one (SNMPv1) and version
two (SNMPv2c). The next figure illustrates an SNMP management operation.
Table 87 Maintenance > RemoteMGMT > FTP
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the AMG1302/AMG1202-TSeries. If
the number is grayed out, it is not editable.
Server Access Select the interface(s) through which a computer may access the AMG1302/AMG1202-
TSeries using this service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
AMG1302/AMG1202-TSeries using this service.
Select All to allow any computer to access the AMG1302/AMG1202-TSeries using this
service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the AMG1302/AMG1202-TSeries using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
