Chapter 25 Remote Management
AMG1302/AMG1202-TSeries User’s Guide
225
Figure 117 Maintenance > RemoteMGMT > WWW
The following table describes the labels in this screen.
Table 85 Maintenance > RemoteMGMT > WWW
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the AMG1302/AMG1202-TSeries
using HTTP or HTTPS. If the number is grayed out, it is not editable.
Server Access Select the interface(s) through which a computer may access the AMG1302/AMG1202-
TSeries using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See Section 4.1 on
page 37 for information on configuring firewall rules.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
AMG1302/AMG1202-TSeries using this service.
Select All to allow any computer to access the AMG1302/AMG1202-TSeries using this
service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the AMG1302/AMG1202-TSeries using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
