Ethernet Switch CLI Reference Guide
123
CHAPTER 35
Mirror Commands
Use these commands to copy a traffic flow for one or more ports to a monitor port so that you
can examine the traffic on the monitor port without interference.
" Use the running configuration commands to look at the current mirror settings.
See Chapter 51 on page 167.
" mirror-filter commands are not supported on all Switch models.
35.1 Command Summary
The following section lists the commands for this feature.
Table 82 mirror Command Summary
COMMAND DESCRIPTION M P
mirror-port Enables port mirroring on the Switch. C 13
mirror-port <port-num> Specifies the monitor port (the port to which traffic flow is
copied) for port mirroring.
C13
no mirror-port Disables port mirroring on the Switch. C 13
interface port-channel <port-
list>
Enters config-interface mode for the specified port(s). C 13
mirror Enables port mirroring in the interface. C 13
mirror dir
<ingress|egress|both>
Enables port mirroring for incoming (ingress), outgoing
(egress) or both incoming and outgoing (both) traffic.
C13
no mirror Disables port mirroring on the port(s). C 13
To Next Page
Loading...
