Chapter 36 MRSTP Commands
Ethernet Switch CLI Reference Guide
126
36.3 Command Examples
This example configures MRSTP in the following way:
• Enables MRSTP on the Switch.
• Activates tree 1 and sets the bridge priority, Hello Time, Maximum Age and Forward
Values for this RSTP configuration.
• Activates MRSTP for ports 1-5 and sets path cost on these ports to 127.
• Adds ports 1-5 to tree index 1.
mrstp interface <port-list> priority
<0-255>
Sets the priority value to the specified ports for
RSTP.
C13
mrstp interface <port-list> tree-index
<tree-index>
Assigns the specified port list to a specific RSTP
configuration.
C13
no mrstp <tree-index> Disables the specified RSTP configuration. C 13
no mrstp interface <port-list> Disables the STP assignment from the specified
port(s).
C13
Table 84 Command Summary: mrstp
COMMAND DESCRIPTION M P
sysname(config)# spanning-tree mode mrstp
sysname(config)# mrstp 1
sysname(config)# mrstp 1 priority 16384
sysname(config)# mrstp 1 hello-time 2 maximum-age 15 forward-delay 30
sysname(config)# mrstp interface 1-5
sysname(config)# mrstp interface 1-5 path-cost 127
sysname(config)# mrstp interface 1-5 tree-index 1
To Next Page
Loading...
