Chapter 47 Queuing Commands
Ethernet Switch CLI Reference Guide
160
47.5 Command Examples: System-Wide
This example configures WFQ on the Switch and assigns weight values (1,2,3,4,12,13,14,15)
to the physical queues (Q0 to Q8).
This example configures the Switch to use WRR as a queueing method but configures the
Gigabit ports 9-12 to use SPQ for queues 5, 6 and 7.
wfq Sets the Switch to use Weighted Fair Queuing (WFQ). C 13
fe-spq <q0|q1| ... |q7> Enables SPQ starting with the specified queue and
subsequent higher queues on the 10/100 Mbps ports.
C13
Table 101 Queueing Command Summary (continued)
COMMAND DESCRIPTION M P
sysname(config)# wfq
sysname(config)# interface port-channel 1-5
sysname(config-interface)# weight 1 2 3 4 12 13 14 15
sysname(config)# wrr
sysname(config)# interface port-channel 9-12
sysname(config-interface)# ge-spq 5
To Next Page
Loading...
