23
Push-Button Configuration
Perform the following steps to create a push-button configuration:
1. Make sure the Zyxel device is switched on and that your device is within the range
of the wireless signal.
2. Enable PBC in one of the following two ways:
a) Press and hold the WPS button on the back panel of the Zyxel device for more
than one second.
b) Log into the Web Configurator and go to Network Settings > Wireless > WPS.
Then enable the WPS function under General and Method 1 PBC under Add a new
device with WPS Method. Click Apply to save the changes.
The Zyxel device then sends the proper configuration settings to the wireless client, which
may take up to two minutes. The wireless client is then able to communicate with the Zyxel
device securely.
To Next Page
Loading...
