8
2.4 Rear Panel
The connection ports are located on the rear panel of the Zyxel device.
Ports/Buttons Function
POWER Connect the power cable here.
ON/OFF Press the ON/OFF button to switch on and o the device.
RESET
If you want to return the device to factory defaults because, for example, you
forgot your password or cannot access the Web Configurator, press and hold the
RESET button until the Power LED starts blinking. The password will be reset to the
factory default (see the device label) and the IP address will be 192.168.1.1.
PHONE 1 -
PHONE 2
Connect analogue phones to the phone ports to make phone calls.
USB Use the USB port for cellular WAN backup, file sharing, media server, & print server.
LAN1 - LAN4 Connect computers or other Ethernet devices to the Ethernet ports for Internet access.
WAN Connect an Ethernet cable to the Ethernet WAN port for Internet access.
WIFI ON/OFF Press the WLAN button for more than one second to enable the wireless function.
The following table describes the ports and buttons of the rear panel:
To Next Page
Loading...
