Chapter 29 Remote Management
EX3510-B1 User’s Guide
246
Figure 159 Maintenance > Remote Management > MGMT Services
The following table describes the fields in this screen.
Table 111 Maintenance > Remote Management > MGMT Services
LABEL DESCRIPTION
WAN Interface
used for services
Select Any_WAN to have the Zyxel Device automatically activate the remote management
service when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the Zyxel Device
activate the remote management service when the selected WAN connections are up.
Service This is the service you may use to access the Zyxel Device.
• HTTP provides a non secured way.
• HTTPS is the secured version of HTTP, it makes sure that your data cannot be read during
transmission.
• FTP is the most common way of communication between 2 devices.
• TELNET provides a way to control your Zyxel Device remotely.
• SSH prevents leakage of data during remote management. Additionally, it can encrypt all
transmitted data.
• SNMP is a management system that monitors devices connected to the Internet.
• PING is a diagnostic tool that can check if your Zyxel Device is connected to the Internet.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from all WAN connections.
Trust Domain Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the trusted hosts configured in the Maintenance > Remote MGMT > Trust
Domain screen.
If you only want certain WAN connections to have access to the Zyxel Device using the
corresponding services, then clear WAN, select Trust Domain and configure the allowed IP
address(es) in the Trust Domain screen.
To Next Page
Loading...
