Chapter 7 Wireless
EX3510-B1 User’s Guide
98
7.4.1 Add/Edit MAC Addresses
Click Add new MAC address in the Network Setting > Wireless > MAC Authentication screen to add a
new MAC address. You can also click the Edit icon next to a MAC authentication rule to edit the rule.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the Zyxel Device
in these address fields. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Figure 57 Network Setting> Wireless > MAC Authentication > Add/Edit
7.5 WPS Settings
WiFi Protected Setup (WPS) allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. To set up a WPS connection between two devices, both
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the Zyxel Device. MAC addresses not listed will be allowed to
access the Zyxel Device.
Select Allow to permit access to the Zyxel Device. MAC addresses not listed will be denied
access to the Zyxel Device.
MAC Address List
Add New MAC
Address
This field is available when you select Deny or Allow in the MAC Restrict Mode field.
Click this if you want to add a new MAC address entry to the MAC filter list below.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the Zyxel
Device.
Modify Click the Edit icon and type the MAC address of the peer device in a valid MAC address format
(six hexadecimal character pairs, for example 12:34:56:78:9a:bc).
Click the Delete icon to delete the entry.
Cancel Click Cancel to restore the default or previously saved settings.
Apply Click Apply to save your changes.
Table 25 Network Setting > Wireless > MAC Authentication (continued)
LABEL DESCRIPTION
To Next Page
Loading...
