ZyXEL Communications EX3510-B1 - Page 51

Chapter 4 Tutorials
EX3510-B1 User’s Guide
51
This tutorial uses the following example IP settings:
To configure a static route to route traffic from N1 to N2:
1 Log into the Zyxel Device’s Web Configurator in advanced mode.
2 Click Network Setting > Routing.
3 Click Add new Static Route in the Static Route screen.
4 Create a new static route using the following settings:
Table 7 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The Zyxel Device’s WAN 172.16.1.1
The Zyxel Device’s LAN 192.168.1.1
IP Type IPv4
Use Interface Ethernet
A 192.168.1.34
R’s N1 192.168.1.253
R’s N2 192.168.10.2
B 192.168.10.33