Chapter 3 Hardware Panels
GS1100 Series User’s Guide
23
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5 Insert the dust plug into the ports on the transceiver and the cables.
Figure 15 Removing the Fiber Cables
Figure 16 Opening the Transceiver’s Latch Example
Figure 17 Transceiver Removal Example
3.2 Rear Panel
The following figures show the rear panels of the Switch. The rear panels contain:
The power receptacle is located on the rear panel of the Switch. Refer to the power supply
requirements on the panel.
To Next Page
Loading...
