GS1100 Series User’s Guide
19
CHAPTER 3
Hardware Panels
This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel
You can use either crossover or straight-through cables for all the ports.
The front panel of the Switch includes the auto-negotiating 10 Base-T/100 Base-TX/1000 Base-T RJ-45
ports and the LEDs.
The GS1100-24 and GS1100-10HP have two SFP slots. Refer to Section 3.1.5 on page 21 for more
information.
The following figures show the front panels of the Switch.
Figure 11 Front Panel
GS1100-16
GS1100-24
GS1100-24E
GS1100-10HP
To Next Page
Loading...
