Chapter 3 Hardware Panels
GS1100 Series User’s Guide
26
If you are uncertain that suitable grounding is available, contact the appropriate electrical inspection
authority or an electrician.
This device must be grounded. Do this before you make other
connections.
3.2.2 Power Connection
Note: Make sure you are using the correct power source as shown on the panel.
GS1100-10HP: Connect the supplied power adapter to the power receptacle on the rear panel. Then
use the included power cord to connect the power adapter to an appropriate power source. Set the
power switch to the ON position.
GS1100-16/24E/24: To connect power to the Switch, insert the female end of the supplied power cord to
the AC power receptacle on the rear panel. Connect the other end of the power cord to an
appropriate power outlet.
3.2.3 LEDs
The LED Indicators give real-time information about the status of the Switch. The following table provides
descriptions of the LEDs.
The following table describes the LEDs.
Table 5 LED Descriptions: GS1100-16/24/24E
LED COLOR STATUS DESCRIPTION
PWR Green On The Switch is receiving power from the power module in the power slot.
Off The Switch is not receiving power from the power module in the power slot.
LINK/ACT Green On The link to a 1000 Mbps Ethernet network is up.
Blinking The Switch is transmitting/receiving to/from a 1000 Mbps Ethernet network.
Amber On The link to a 10 Mbps or a 100 Mbps Ethernet network is up.
Blinking
The Switch is transmitting/receiving to/from a 10 Mbps or a 100 Mbps
Ethernet network.
Off The portis not connected to an Ethernet network or the Switch is shut down.
Uplink
Port LED
(SFP)
Green On The port is connected to an Ethernet network at 1000 Mbps.
Blinking The port is receiving or transmitting data at 1000 Mbps.
Amber On The link to a 100 Mbps Ethernet network is up.
Blinking The port is receiving or transmitting data at 100 Mbps.
Off The port is not connected to an Ethernet network or the Switch is shut down.
Table 6 LED Descriptions: GS1100-10HP
LED COLOR STATUS DESCRIPTION
PWR Green On The Switch is receiving power from the power module in the power slot.
Off The Switch is not receiving power from the power module in the power slot.
To Next Page
Loading...
